015 & 016 SPRAYABLE CONTACT ADHESIVE TIMBATECH PREMIUM CLEAR SPRAY CONTACT ADHESIVE - 20L TIMBATECH PREMIUM RED SPRAY CONTACT ADHESIVE - 20L

TIMBATECH PREMIUM CLEAR SPRAY CONTACT ADHESIVE - 20L

TT015 is a sprayable solvent based contact adhesive which offers a high strength heat-resistant bond that is resistant to water, many household chemicals and the effect of ageing. 

It is designed for use in the furniture and building trade for bonding a wide range of surfaces such as fabric backed plastics, plywood, particleboard, MDF, wood veneer, plasterboard, laminated plastics, aluminium, mild steel, galvanised iron and polyurethane foam without the need for clamps or mechanical support. It is used in the manufacture of counter tops, table tops, desk tops, vanities, furniture, sandwich panels, doors, cabinets, partitions, wall panels and other laminated products.

APPLICATIONS 

Mix thoroughly before use.   

• TT015 can be applied using conventional air-spray equipment.  Spray adhesive to both surfaces to be bonded. Apply adhesive to approximately 80% coverage over the entire area, half in a north-south spray pattern and half east-west. Apply additional adhesive to edges or areas that will be post-formed to achieve 100% coverage. 
• Allow surfaces to dry before bonding. This will take 5-10 minutes when cold spray equipment is used. A longer drying time may be necessary under high humidity conditions. When dry, the adhesive will feel tacky, but will not transfer to the finger when touched. 
• Surfaces should be joined within 30 minutes after application. If the surfaces are not joined within this time, they can be re-activated by applying another coat of adhesive. 
• Combining the surfaces with a minimum of 276 Kpa (40PSI) bond pressure is suggested for best results. A pinch roller or rotary press is recommended. If not available, use a 75mm rubber hand roller and apply pressure from the centre toward edges to avoid air pockets and bubbles. Do not use so much pressure as to crush core materials. 

TIMBATECH PREMIUM SPRAY CONTACT ADHESIVE RED - 20L

TimbaTech 016 is a sprayable solvent based contact adhesive which offers a high strength heat-resistant bond that is resistant to water, many household chemicals and the effect of ageing.
It is designed for use in the furniture and building trade for bonding a wide range of surfaces such as fabric backed plastics, plywood, particleboard, MDF, wood veneer, plasterboard, laminated plastics, aluminium, mild steel, galvanised iron and polyurethane foam without the need for clamps or mechanical support. It is used in the manufacture of counter tops, table tops, desk tops, vanities, furniture, sandwich panels, doors, cabinets, partitions, wall panels and other laminated products.