280.51 JOWATHERM HOTMELT GLUE WHITE 25KG BAG

280.51 JOWATHERM HOTMELT GLUE WHITE 25KG BAG

Application:
Edgebanding
For bonding thermoplastic edgebands (e.g. ABS, PP, PVC), edgebands made of resinated decor paper, or veneer (with or without fleece backing).
The properties of the bonded parts and, where necessary, the reverse primer coating of the edgebanding materials have to undergo application-related testing prior to use.

Directions for Use:
The adhesive granulate can be processed using automatic feed systems. In that case, the ambient temperature should not exceed 30 °C.
Different types of hot melt adhesives may be incompatible with each other depending on the formulation. Therefore, we recommend to carefully clean the application equipment when changing the product. Further information is available upon request.
The processing characteristics may vary depending on the application technology used as well as at differing feed speeds. Preliminary testing has to be carried out in order to assess the effect on the bonding process.
Customer trials are required.

Requirements for a High-Quality Bonding Process:
The properties (e.g. surface tension, plasticizer content…) and the conditioning of the substrates, as well as the processing conditions (e.g. ambient temperature, humidity…) will influence the processes of joining and bonding.

Customer tests under consideration of everyday production conditions are therefore absolutely necessary to define stable process parameters and to ensure that the product is fit for purpose. For best bonding results, the materials to be bonded should be free of dust, oil, and grease, and be dry. Wood moisture content should be at 8 – 10 %. Ideally, the minimum temperature should be at 18 °C. Avoid draft.
Our Application Technology Department and our Application Specialists will provide technical data to assist you in your choice of an appropriate product for your requirements.
As a suggestion on how to establish high-quality bonding processes, please refer to DIN 2304.
Cleaning: Preliminary mechanical cleaning while hot (e.g. with a suitable spatula which does not damage the unit). Remove any residues in the application environment when cold using Jowat® Cleaner 402.40.

Safety Considerations:
Like all hot liquids, this product can cause severe burns in the molten state.
Please take appropriate precautions to prevent the hot adhesive from coming into contact with the skin (e.g. by wearing appropriate protective gloves). If this does happen, cool the affected area immediately with plenty of cold water. Do not try to remove the adhesive from the skin. Seek medical attention.
Hot melt adhesives with hazard-free labeling may release vapors when processed. It is recommended not to exceed the indicated processing temperature, to keep the formation of vapors as low as possible. Extraction and ventilation are recommended especially if an open  application system is used.

Storage:
The product should remain stored in closed original containers, dry and cool.
For best-before date, please see container label.
After the elapse of the best-before date, it is essential that you again verify that the product is fit for your intended application.